Which bearing fit record applies after a wind shaft seat has been repaired?

Small wind / Buyer questions

Mechanical and structural acceptance

Which bearing fit record applies after a wind shaft seat has been repaired?

The short answer

Use the accepted dimensions and surface condition of the finished seat together with the actual mating bearing. A pre-repair inspection can explain the original condition, but it does not describe a surface that was subsequently changed. Confirm whether the repair restores the original interface or establishes a separately approved one.

Separate the defect record from the final inspection

The incoming report may describe wear, local damage or a dimension before any material was removed. An intermediate result may describe a prepared surface before its final finish. Keep those records in the repair history and identify the finished measurement that is intended to support release.

The final result should identify the seat, inspected positions, drawing or repair revision and the applicable size, form and surface requirements. A single historical diameter is insufficient to describe that state.

Check which bearing belongs to the repaired seat

SKF discusses wind turbine shaft repair cases in which an adjusted seat diameter may be paired with a corresponding bearing bore. Such options depend on the specific assessment and do not authorize a generic change to the bearing or shaft.

If a quote says the seat has been restored, ask what dimensions that means and which bearing identity the inspection supports. If the repair changes the interface, retain the approved deviation and its matched replacement specification.

Close the actual fit and handover record

Ask the repairer to link the finished inspection to the shaft identity and the mating bearing specification. Have the responsible designer resolve any remaining fit, surface or support issue before using the original acceptance basis. Retain the as-repaired configuration for the next service team so it does not order from an obsolete interface drawing.

Sources

Examples are illustrative. Confirm product-specific performance, compatibility and supply scope in the applicable documents.