Small wind / Buyer questions
Mechanical and structural acceptance
Can a cold-site shaft measurement be compared directly with the specified wind equipment fit?
The short answer
Compare the measured dimensions with the specification only after establishing their temperature basis. A cold shaft or bore can have different dimensions from the same part at the drawing reference temperature. The inspection record should explain any correction and uncertainty that affect the fit decision.
Read the reference temperature on the applicable documents
NIST explains that 20 °C is the standard reference temperature in dimensional metrology unless an applicable requirement states another basis. This is a reference for reporting and evaluating geometry. It is separate from the temperature at which the finished equipment operates.
Record the drawing revision and any specified exception. Ask whether the supplier’s numbers are raw readings or values already reported at the reference temperature. A second correction could otherwise be applied to the same result.
Account for the conditions of both measurements
The shaft, the mating bore and the measurement system may have different temperature histories. Their materials can also expand by different amounts. An air temperature recorded at the workbench does not necessarily establish the temperature of a component just removed from cold storage.
The metrology reviewer should identify whether part temperature, thermal gradients or uncertainty in material expansion can change the apparent clearance or interference. A reported difference near the tolerance boundary deserves that context.
Request comparable shaft and bore results
Ask for the component identities, measured conditions, dimensional basis and any correction or uncertainty statement. Compare the reported sizes at the specified basis before assessing the required fit. If the available record cannot resolve the tolerance, agree an appropriate repeat measurement instead of interpreting temporary assembly temperature as proof of permanent dimensional conformity.
Sources
- NIST Engineering Metrology Toolbox: reference temperature and dimensional uncertainty
- NIST dimensional measurement uncertainty away from the reference temperature
Examples are illustrative. Confirm product-specific performance, compatibility and supply scope in the applicable documents.