Small wind / Buyer questions
Purchasing and service handoff
What evidence is needed before a wind gear unit shipped without service oil is released for commissioning?
The short answer
A gear unit may have been drained for transport, or it may contain a preservation fluid. Delivery without service oil does not by itself show a defect. Confirm the exact unit’s dispatch condition, preservation instructions and approved service lubrication record before signing the commissioning release.
Reconcile the serial number with the dispatch record
Ask the supplier to identify the delivered gear unit, any separately shipped lubrication equipment and the documented oil state at dispatch. A run test before shipment can use a different fill state from the delivered assembly. Keep both records and check which accessories and lines belong to the actual unit.
Flender’s assembly instructions include examples of gear units transported after operating oil has been drained. The applicability depends on the selected unit and its instructions.
Separate preservation evidence from operating readiness
A visible film or a small amount of fluid does not establish that the service lubrication requirement is satisfied. Verify whether the unit was preserved internally and whether the product instructions require specific preparation. Storage duration and changes in the preservation condition can also affect the review.
Ask the supplier which information needs recording for the actual equipment, including identification of the specified lubricant and the documented service fill state. Do not infer these from the nameplate power.
Close the release at the correct milestone
Keep the receiving inspection, preservation review and commissioning readiness decision separate. Have the responsible technicians verify the supplier instructions and record the completed checks before operation. If the records disagree, treat the lubrication state as unresolved until the equipment specialist reconciles them. This example describes a generic purchasing and handoff decision, without specifying a MARSTON gear unit or lubrication procedure.
Sources
- Flender gear unit assembly instructions: transport and delivery condition
- Flender gear unit preservation instructions
Examples are illustrative. Confirm product-specific performance, compatibility and supply scope in the applicable documents.