Small wind / Buyer questions
Mechanical and structural acceptance
Does stationary continuity prove a wind slip ring maintains contact while moving?
The short answer
A stationary continuity reading can help identify a connected path at the measured position. It cannot establish how the contact behaves during movement. Ask for evidence matched to the intended circuit and the supplier’s approved test conditions before treating static continuity as proof of dynamic performance.
Define what the stationary test covered
The record should identify the exact circuit, terminal pair, slip-ring position and parts included in the measurement. A meter can report a continuous path through the ring and its wiring at rest. That result does not reveal every brief interruption or resistance change that could occur in another position.
Keep circuit identification, insulation testing and dynamic transfer evidence separate. They can have different methods, limits and acceptance purposes.
Match the moving test to the intended service
Moog distinguishes dynamic contact resistance and electrical noise among slip-ring design considerations. A power circuit may be reviewed for its voltage or current transfer under specified conditions. A signal path may need evidence that addresses the sensitivity and protocol of its actual application.
The meaningful test conditions depend on the specific rotary joint and what it carries. A passing result for a power path does not settle the performance of a separate data circuit.
Specify the evidence needed at the installation boundary
Ask the supplier to identify the circuits, approved motion range, acquisition capability and acceptance criteria used in any relevant moving test. Retain the equipment identity and the conditions covered by the result. If the work order includes only a stationary check, keep the dynamic requirement open until the responsible reviewer has suitable evidence.
Sources
- Moog slip-ring catalogue: dynamic contact resistance and electrical noise
- Moog application guidance: specify circuit and service requirements
Examples are illustrative. Confirm product-specific performance, compatibility and supply scope in the applicable documents.