Small wind / Buyer questions
Electrical diagnostics and service tests
Can a PTP clock report synchronization after one network direction takes a longer path?
The short answer
A timing exchange can continue while the forward and reverse network paths have unequal delays. Cisco documents that path asymmetry can affect PTP accuracy and describes compensation for supported, defined conditions. The synchronization state alone does not show how large the actual clock error is. Check the direction of the route change and compare the endpoint's time with a suitable reference.
Map the active path in both directions
Record the reference clock, endpoint and active timing transport. Identify the links and devices used in each direction before and after the event. In a hypothetical failover the timing messages still arrive, but one direction now follows a longer path. A similar round-trip observation would not establish that the one-way delays remained equal. The delay in one direction can increase while the other direction changes differently, so record the path change itself.
Test the clock rather than infer the offset
Ask the qualified network and measurement teams which independent comparison can verify time error at the affected endpoint. Preserve source identity and path observations with the measured error. Separate a repeatable directional difference from time-varying queueing or other changes. A fixed compensation described for one platform or path does not automatically cover a variable event.
Record the applicable path conditions
Retain the approved topology, tested operating paths and timing evidence for each required state. If a change alters the routing assumptions, bring the condition back into the timing acceptance review. Do not infer a compensation value from a generic example. This supports engineering handover without equating working telemetry with an unchanged clock offset.
Sources
Examples are illustrative. Confirm product-specific performance, compatibility and supply scope in the applicable documents.