Small wind / Buyer questions
Electrical diagnostics and service tests
Why can two proximity sensors work individually but chatter together?
The short answer
Test the combination under its intended mounting and operating conditions. Omron describes mutual interference when an adjacent proximity sensor affects the sensing field and makes the output unstable. An individual sensor test can therefore pass while the two installed channels show intermittent states. This is a different observation from a loose wire or an incorrectly placed target, even though the controller may log similar input changes.
Document the sensor pair
Record both model codes, mounting orientation, face-to-face or side-by-side spacing, surrounding metal and target path. The specified spacing can depend on the particular models and arrangement. Ask the supplier which combinations and conditions its guidance covers. In a hypothetical assembly the symptoms begin after a second position sensor is replaced with a model whose permitted spacing differs from the original.
Compare individual and simultaneous evidence
In the approved test arrangement, correlate raw input changes with the operating states of both sensors and the actual target movement. Look for instability with a stationary target and compare evidence when neighboring devices are in their relevant operating states. Keep the supply and wiring observations available, because electrical faults can also cause intermittent inputs. The test should preserve the equipment's protection and approved method of operation.
Record the accepted configuration
If the supplier calls for changed separation or an approved combination of sensor variants, identify the exact revision of the assembly and repeat the applicable functional check. Keep the result with both spare codes and the arrangement, since later replacement of only one device can change the pair. The acceptance decision should show that simultaneous operation was observed under the conditions relevant to the installed equipment.
Sources
Examples are illustrative. Confirm product-specific performance, compatibility and supply scope in the applicable documents.