Small wind / Buyer questions
Electrical measurement evidence
Can a compensated probe still alter a wind control signal?
The short answer
Yes. Correct compensation addresses the response of a probe and instrument combination; it does not make the probe an electrically absent observer. Tektronix explains that probe-tip capacitance can affect transition times and high-frequency amplitude. The loading question therefore includes the actual signal source and its impedance. Ask whether the approved measurement arrangement sufficiently preserves the circuit behavior being assessed.
Identify the circuit as well as the probe
Record the observation point, source information, probe model and accessories, relevant input impedance or capacitance, and the transitions of interest. A high resistance specified for DC does not describe the complete loading at faster signal frequencies. Keep the equipment designer's permitted observation method with the test plan. Calibration and compensation records remain relevant, but answer different parts of the measurement review.
Review a change that appears when observation begins
In a hypothetical yaw-controller investigation, a discrete signal behaves differently with a particular probe present. The trace may faithfully show the circuit after loading rather than the behavior that existed before measurement. Ask the qualified reviewer to assess the source and probe combination and any approved comparative evidence. Do not assign the change to a failed controller solely because the oscilloscope displays a clean, repeatable waveform.
Retain a supported observation boundary
Keep the accepted loading assessment, instrument configuration and actual operating state beside the waveform. If another supported measurement arrangement is used, identify the relevant differences and which conclusion each record supports. A compensation check should retain its own scope instead of serving as proof that loading is negligible. This gives the buyer evidence for deciding whether the observed edge represents the intended control interface under its required operating conditions.
Sources
Examples are illustrative. Confirm product-specific performance, compatibility and supply scope in the applicable documents.