Can peak acceleration close a wind vibration acceptance requirement written in RMS velocity?

Small wind / Buyer questions

Mechanical and structural acceptance

Can peak acceleration close a wind vibration acceptance requirement written in RMS velocity?

The short answer

A peak acceleration summary alone cannot establish an RMS vibration velocity requirement. A qualified analyst may be able to derive the required quantity from suitable original data. Check the sensor location, operating condition, usable bandwidth and processing against the agreed acceptance method before signing.

Read the requirement and result side by side

Record the required unit, statistic, frequency band, measurement location and direction. A peak acceleration value describes the maximum of a measured acceleration record. RMS velocity describes the root mean square of a velocity signal over the defined evaluation interval and bandwidth.

A report with a calibrated instrument can still miss the required quantity. Preserve the original summary and identify precisely which part of the acceptance requirement remains unsupported.

Check whether the original measurement can be reprocessed

Acceleration and velocity are related by integration. For a single sinusoid their amplitude ratio depends on frequency, and the RMS to peak relationship depends on the waveform. A broadband acceleration peak has no single frequency or waveform factor that can turn it into an overall RMS velocity.

Ask for the calibrated time record and metadata needed to validate conversion and filtering. The measurement chain must have captured the required frequencies without overload. A suitable detailed spectrum can also support review if its amplitude definitions and processing are documented.

Close only the agreed clause

Have the reviewer record the derived quantity, method, applicable operating states and any unresolved data limitations. Where the original acquisition cannot support the agreed method, obtain a new measurement under the approved plan. Use the project criterion and the actual equipment instructions for the acceptance decision.

Sources

Examples are illustrative. Confirm product-specific performance, compatibility and supply scope in the applicable documents.