Small wind / Buyer questions
Electrical diagnostics and service tests
Does a healthy trip-circuit supervision signal prove that a wind feeder breaker can open on command?
The short answer
Trip-circuit supervision can indicate that a monitored electrical path meets its health criteria in a particular state. Its scope depends on the supervision scheme and breaker position. A healthy status does not demonstrate that the trip supply will perform under demand or that the mechanism will open the power contacts.
Identify the monitored path in each breaker state
Use the as-built trip schematic and the supervision logic to identify the parts actually observed. The supervised route can include the supply, fuses, wiring, coil and auxiliary contacts in different arrangements. Schneider Electric's MiCOM guidance gives model-specific examples of continuity monitoring and circumstances in which supervision is inactive. Obtain the actual enable conditions and state-dependent coverage. A maintenance record should distinguish a healthy status from an unavailable or disabled indication.
Distinguish continuity from performance under demand
A monitored circuit can appear complete without proving that it will deliver the required energy during an operation. The electrical continuity path also says little by itself about how the release, latch and breaker mechanism respond. Ask whether the project has a separate record of the accepted control supply and the required mechanical or contact response. Keep the endpoint explicit. An auxiliary indication can be informative while still differing from evidence for the main power contacts.
Close the maintenance item against the required evidence
Request the supervision function description, accepted circuit drawing and most recent verification for the installed breaker. Ask the responsible electrical team to identify which checks establish supervision coverage and which establish the intended breaker operation. If the only available record is a healthy indication, preserve it as evidence of the observed supervision state and leave the operational check open. Assign any further verification to qualified personnel under the equipment and project procedures.
Sources
- Schneider Electric MiCOM P126 and P127 Trip Circuit Supervision
- Schneider Electric EvoPacT breaker maintenance guidance
Examples are illustrative. Confirm product-specific performance, compatibility and supply scope in the applicable documents.