Small wind / Buyer questions
Resistor ratings and accuracy data
Can resistor wattage alone establish a continuous voltage limit?
The short answer
No. A resistor can remain below its power limit while exceeding an independent continuous voltage ceiling. ROHM explains that the voltage derived from √(P × R) must be compared with the maximum element voltage, with the lower applicable value governing. The calculation therefore requires the actual part's voltage specification as well as its resistance and permissible power under the stated conditions.
Request both limits from the offered specification
Identify the series, size, resistance value, power basis and maximum element voltage in the supplier's documents. Keep continuous working voltage separate from any short-duration overload or dielectric-withstand figure. Those labels do not establish the same stress boundary. An offer stating only resistance and watts leaves an important continuous-voltage acceptance question unanswered.
Assess a higher-resistance substitution explicitly
In a hypothetical wind-project sensing assembly, a proposed resistor has the same wattage but a higher resistance. The calculated power at the planned voltage may appear acceptable. That arithmetic alone does not qualify the replacement: the engineer still needs its specified element voltage ceiling and the applicable operating conditions before deciding whether the proposed stress is within its limits.
Record the governing constraint in the review
Retain the actual component voltage specification alongside the power calculation and its assumptions. State which constraint governs the accepted operating condition, and obtain clarification if a catalogue combines several voltage terms without definitions. A passing wattage calculation is one part of component qualification. It does not approve a circuit voltage, insulation arrangement or installed modification, and no MARSTON component rating is established by this example.
Sources
Examples are illustrative. Confirm product-specific performance, compatibility and supply scope in the applicable documents.