Small wind / Buyer questions
Mechanical inspection and field service
Can static shaft offset and dynamic runout be treated as the same seal limit?
The short answer
A shaft centerline can sit off center relative to the seal bore, and the shaft surface can also move radially as it rotates. SKF's seal handbook distinguishes shaft-to-bore misalignment and dynamic runout. The lip responds to the geometry and motion at its own running track. A single indicator reading with an unspecified setup does not identify which condition the repair record covers.
Define both references
Ask the reviewer to identify the seal bore centerline, shaft reference and measurement location. Record how the shaft was supported and which part was rotated, if applicable. In a hypothetical assembly, the shaft runs with little variation about its own axis but the housing bore is offset from it. Another assembly can have a centered bore while the running surface varies through a turn. They need different observations.
Match the measurement to the sealing track
Compare the reported positions with the actual seal axial location and the equipment state being assessed. Retain measurements made before or after final assembly as distinct records. A result taken at a distant shaft end may not describe the same geometry. The applicable limits depend on the seal design and conditions, including rotational speed where the supplier specifies it.
Review the interface as installed
Record the measured static offset and dynamic runout using the definitions in the applicable specification. Ask how any combined condition is evaluated for the proposed seal. Do not substitute a generic shaft dimension or bearing runout value for the specified evidence. The service decision should name the exact seal and the tested assembly so later reviewers can tell whether the relevant lip tracking condition was observed.
Sources
Examples are illustrative. Confirm product-specific performance, compatibility and supply scope in the applicable documents.