Small wind / Buyer questions
Capacitor qualification and service conditions
Does normal capacitance rule out a mechanical crack in a converter MLCC?
The short answer
No. A normal capacitance result does not exclude every mechanical crack in a multilayer ceramic capacitor (MLCC). KYOCERA AVX describes fractures that are not initially apparent in capacitance and Q-factor testing, with electrical degradation developing later if moisture enters a crack. This is a specific latent-damage limitation, not a claim that every normal-reading MLCC is damaged.
Connect the concern to actual mechanical history
Request the assembly identity, reported damage or handling event and the supplier's relevant manufacturing or inspection records. Identify whether the concern involves board flexure or another credible mechanical stress. A capacitance result can answer its specified electrical measurement question while leaving the separate fracture concern unresolved. The two records should not silently be treated as equivalent screening evidence.
Review a hypothetical returned control board
A converter control board is returned after a documented mechanical handling incident. The inspection summary reports capacitance within tolerance for the affected MLCCs and proposes release on that basis alone. The purchaser asks how the mechanical damage concern was evaluated. The request does not diagnose a fracture; it asks whether the stated release evidence actually addresses the suspected failure mechanism.
Retain a qualified damage disposition
Ask the equipment manufacturer or qualified failure-analysis provider for the appropriate evaluation and acceptance decision for the assembled board. Keep its scope and limitations with the service record. This FAQ prescribes no board bending, destructive inspection or insulation-resistance test on connected electronics. It distinguishes latent mechanical integrity from an initial capacitance check without inventing a MARSTON inspection procedure.
Sources
Examples are illustrative. Confirm product-specific performance, compatibility and supply scope in the applicable documents.