Small wind / Buyer questions
Application loads and feasibility
Can a grain dryer’s heater stop mark the end of its electricity demand in a dryeration system?
The short answer
No, where the accepted process transfers hot grain for tempering and later cooling. The dryer’s heating stage may finish while other electrical loads remain or start in a separate bin. The intended grain condition and sequence determine whether the later load can move in time. Capture the whole service before estimating how much electricity can coincide with wind.
Identify the point where each process stage ends
Ask the operator for the approved sequence and the equipment that handles transfer, tempering, cooling and final storage. University of Minnesota Extension describes dryeration as a method that transfers hot grain from the dryer, allows a tempering period and then cools it with air. The example does not set safe times or grain conditions for a particular site. Confirm the process owner’s accepted limits and the measurement points.
Record separate electrical loads through the sequence
Collect timestamps for heater operation, conveyors and the cooling fan, with the corresponding batch or lot identity. If a dryer meter ends at the dryer panel, it may omit later fan use in the receiving bin. A whole-site meter may include that power without identifying the stage. Use equipment-state records to reconcile the boundary and keep overlapping batches visible. Do not add a submeter total twice to the same site record.
Compare wind with the accepted sequence and constraints
Send measured loads and the usable scheduling range for each stage. Distinguish an approved delay from a period the load has simply gone unmeasured. Cooling may be required even if the wind available during that period is low. An assessment can compare a realistic wind contribution without assuming the drying process ends when the heater turns off or that the operator can defer a required service until the weather changes.
Sources
Examples are illustrative. Confirm product-specific performance, compatibility and supply scope in the applicable documents.