What proves a relocated meter still represents the wind site's connection-point export?

Small wind / Buyer questions

Electrical diagnostics and service tests

What proves a relocated meter still represents the wind site's connection-point export?

The short answer

Compare a suitable independent measurement at the connection point with the value the export controller actually uses after the move. A relocated meter may need other measured inputs to reconstruct the site total, if the installed architecture supports that approach. Fronius documents model-specific meter-position alternatives. Acceptance evidence should cover the reconstructed quantity under representative source and load combinations and include the permitted measurement discrepancy.

Compare the old and new single-line drawings

Identify the utility connection, meter, sources and branches that contribute to power at the connection. Record which loads and sources are included before and after the move. The same meter model and export-limit number can describe a different physical boundary after a relocation.

Compare reconstructed and independently measured export

In a hypothetical retrofit, one meter is relocated and the controller is designed to combine its value with a second measurement. Ask for simultaneous recordings of the separate inputs, the controller's computed connection quantity and a suitable independent reference at the connection point. Compare the readings under cases that change the contribution of each branch. A close match during one quiet period does not establish equivalence across all agreed operating cases.

Re-establish the evidence for the installed arrangement

Retain the as-built meter position, phase mapping, controller configuration and results for the agreed site cases. Ask which approvals or retests apply before accepting the changed arrangement. This lets the wind supplier evaluate its intended measurement and control boundary without relying on the settings from an earlier installation. Keep the test drawing and the raw measurement record together so later reviewers can reproduce the boundary comparison.

Sources

Examples are illustrative. Confirm product-specific performance, compatibility and supply scope in the applicable documents.