Small wind / Buyer questions
Procurement and engineering handover
Can equal air and contact discharge voltages be treated as equivalent tests?
The short answer
Treat air discharge and contact discharge as distinct methods in the applicable equipment ESD immunity test. IEC 61000-4-2 addresses electrostatic discharges affecting electrical and electronic equipment. A matching voltage figure alone does not identify the discharge method, the point tested or the equipment's observed behavior. Procurement teams evaluating two reports need the applied method and test scope as well as the reported level.
Locate the tested interface
Request the edition, tested model and hardware configuration, equipment state, applied method, discharge points and monitored functions. Distinguish tests on exposed interface points from any indirect discharge arrangement listed in the report. A front-panel assembly, a separate control board and a complete cabinet can expose different interfaces to users. Use photographs or diagrams from the report to match those interfaces to the installed configuration.
Read the results point by point
In a hypothetical comparison one supplier lists a single voltage in a brochure, while another identifies the test method and observations for each accessible interface. The number is easier to interpret in the second case because the report connects it to the specimen and criterion. Ask which surfaces or ports were excluded and why. That question also helps when a touch panel, door fitting or connector is revised after testing.
Record the unresolved portion
Match the required methods and points to the documented evidence and flag any missing item for the responsible reviewer. Keep records of transient functional degradation or recovery if the criterion calls for them. Use qualified laboratory evidence for the applicable configuration. A report about packaged spare handling or component-level protection cannot by itself settle an equipment-level interface requirement, which has its own test boundary.
Sources
- IEC 61000-4-2 — Equipment electrostatic discharge immunity
- ESD Association — Basic ESD control procedures and materials
Examples are illustrative. Confirm product-specific performance, compatibility and supply scope in the applicable documents.