How can a drive overvoltage during deceleration differ from high incoming supply voltage?

Small wind / Buyer questions

Electrical diagnostics and service tests

How can a drive overvoltage during deceleration differ from high incoming supply voltage?

The short answer

A DC bus overvoltage can be associated with energy returning from a decelerating load, as well as other conditions such as high incoming voltage. ABB's drive guidance discusses overvoltage control and checking supply conditions. The alarm text identifies the drive's detected condition, while the event history helps explain why it occurred. Record the input, bus and motion evidence together before changing a supply or drive configuration.

Compare the event timing

Request the relevant recorded supply voltages, bus trend, commanded deceleration, measured or estimated motion and any braking states. Keep the samples and their timestamp limits visible. In a hypothetical machine the input supply remains within its observed range while bus voltage rises during a commanded stop. Another event occurs while the load state is unchanged and the input increases. The two patterns justify different follow-up.

Identify where energy can go

Review the documented drive arrangement and the installed equipment that handles braking energy. A controller, resistor or regenerative arrangement should be identified from the actual design. Record whether its behavior was observed during the incident. A high bus reading alone does not confirm that any particular component is defective or that a replacement can accept continuous generating operation.

Use the evidence for the correct review

Have the responsible reviewer compare the event with the approved stopping duty and supply limits. Retain any unresolved gap in the event record. If an electrical supply proposal changes the operating conditions, include the actual deceleration behavior in its assessment. This makes the cause review traceable without choosing a new stop setting or assuming the site source produced the alarm.

Sources

Examples are illustrative. Confirm product-specific performance, compatibility and supply scope in the applicable documents.