Small wind / Buyer questions
Electrical diagnostics and service tests
Can a zero-loss condensate drain still waste compressed air?
The short answer
Yes. A zero-loss drain is intended to remove collected liquid without continually venting useful compressed air. Its label identifies the design. A valve that remains open can still lose air, while a valve that remains closed can leave condensate in the equipment. The U.S. Department of Energy identifies both failure modes in its compressed-air sourcebook. The two faults have different effects on the electrical load and on the quality of air delivered downstream.
Identify which drain and which state produced the observation
Record the separator, receiver, filter or dryer served by the drain, its control design and the time of the observation. A short discharge during an expected drain event and a sustained loss while the drain should be shut are different findings. A quiet drain also has several possible explanations, including a period with little condensate.
Keep liquid removal and air consumption separate
The plant record can pair drain status or alarms with observed liquid discharge, supply pressure and compressor operation. In a hypothetical case, a compressor loads more frequently during a no-production period. That change supports an investigation of air losses, but the compressor record alone does not identify which drain, valve or fitting is involved. Use only observations obtained by the responsible maintenance team under the site's pressure-equipment procedures.
Use an accepted operating baseline in the wind assessment
Request a dated post-service record with the drain identity and comparable production conditions. Keep the original measurement as a separate case where the project may have to operate before repairs are complete. This shows how much of the recorded electrical demand belongs to the installed plant condition and whether any condensate quality risk remains open.
Sources
- U.S. Department of Energy compressed-air maintenance and automatic drain failure modes
- Kaeser air-treatment maintenance guidance for condensate drains
Examples are illustrative. Confirm product-specific performance, compatibility and supply scope in the applicable documents.